wiki:Maschinen/LaserCutter

Version 8 (modified by gismo, 15 years ago) (diff)

--

Technische Daten

  • Arbeitsfläche: 400x400mm (eher 420x420mm)
  • Laser Leistung: 50Watt max.
  • Laser Röhre: IR/CO2, Wasserkühlung
  • Importformate: Schneiden dxf, Gravieren png, jpg, bmp
  • Gravieren: 300dpi scanmode
  • Schneiden: 5mm Sperrholz, 6-7mm Acryl, 4-5mm Papkartoon etc.

RFA Lazor Howto

Boot the Lazor

  • Apply Safty Glasses (if avail)
  • Power up Water Pump
  • Power up Ventilation
  • Turn Lazor Power down (Carves regulation to CCW)
  • Turn on the Lasor (check power cord, flip "End Switch")
  • Check Ventilation and Water Pump

Material

  • Alignment for objects is from left to right and from top to bottom
  • Try to align to the left most Position (X Axes end stop)
  • Use flat Material only!
  • No Materials with Chlorine! (Make Fire test to check)

Before Fire

  • Dobble check 'Move Frame' or 'Move Rect' before fire!
  • DON'T USE 'DRAW FRAME' or 'DRAW RECT' (buggy)
  • Shout "Fire the Lazor!" when ready

During Fire

  • If you see flames, somethings wrong! (add more Fan power or stop Process)
  • Don't look into plasma! (this is what you see glowing)
  • Don't look the into beam with remaining eye
  • When Job is done, keep Lid closed for a few more seconds.

Wertetabellen

eigene Erfahrungen

die tabelle zeigt werte bei welchen die angegebene dicke als 'schnittiefe' erzielt wird (also durchgeschnitten, bei voll aufgedrehter Lazerleistung)

MaterialSourceThicknessnumber of runscutting speedresult
pappel sperrholzobi4mm18mm/secdurch
pappel sperrholzobi3.7mm-4mm220mm/secdurch
birke sperrholzobi4mm1-33-20geht nich durch

epilog erfahrungen 3.

Open Tickets

Einstellungen / Erfahrungswerte

  • Maßstäblichkeit / fine scaling: siehe #102

Attachments (4)

Download all attachments as: .zip